ECS4660-28F_Management Guide-R03

C HAPTER 24 | System Management Commands
Precision Time Protocol
– 970 –
DEFAULT SETTING
0 (1 second)
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ The log base 2 settings equate to the following values:
■
0 – 1 packet every second
■
1 – 1 packet every 2 seconds
■
2 – 1 packet every 4 seconds
■
3 – 1 packet every 8 seconds
■
4 – 1 packet every 16 seconds
■
5 – 1 packet every 32 seconds
◆ This command is only applicable for interfaces which are set to use the
peer-to-peer delay mechanism with the ptp delay-mechanism
command.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ptp log-min-pdelay-request-interval 1
Console(config-if)#
ptp
log-sync-interval
This command sets the synchronization message transmit interval. Use the
no form to restore the default setting.
SYNTAX
ptp log-sync-interval interval-value
no ptp log-sync-interval
interval-value – The minimum interval between (multicast)
synchronization messages. (Range: -1 - 1 in log base 2)
DEFAULT SETTING
0 (1 second)
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ The log base 2 settings equate to the following values:
■
- 1 – 1 packet every 1/2 second
■
0 – 1 packet every second
■
1 – 1 packet every 2 seconds