ECS4660-28F_Management Guide-R03

C HAPTER 24 | System Management Commands
SMTP Alerts
– 942 –
COMMAND MODE
Global Configuration
COMMAND USAGE
The specified level indicates an event threshold. All events at this level or
higher will be sent to the configured email recipients. (For example, using
Level 7 will report all events from level 7 to level 0.)
EXAMPLE
This example will send email alerts for system errors from level 3 through
0.
Console(config)#logging sendmail level 3
Console(config)#
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the no
form to remove a recipient.
SYNTAX
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
EXAMPLE
Console(config)#logging sendmail destination-email [e-mail]
Console(config)#