ECS4660-28F_Management Guide-R03

C HAPTER 24 | System Management Commands
Event Logging
– 933 –
EXAMPLE
To show all lines, enter this command:
Console#show line
Console Configuration:
Password Threshold : 3 times
Inactive Timeout : Disabled
Login Timeout : Disabled
Silent Time : Disabled
Baud Rate : Auto
Data Bits : 8
Parity : None
Stop Bits : 1
VTY Configuration:
Password Threshold : 3 times
Inactive Timeout : 600 seconds
Login Timeout : 300 sec.
Silent Time : Disabled
Console#
EVENT LOGGING
This section describes commands used to configure event logging on the
switch.
Table 68: Event Logging Commands
Command Function Mode
logging facility Sets the facility type for remote logging of syslog
messages
GC
logging history Limits syslog messages saved to switch memory based
on severity
GC
logging host Adds a syslog server host IP address that will receive
logging messages
GC
logging on Controls logging of error messages GC
logging trap Limits syslog messages saved to a remote server
based on severity
GC
clear log Clears messages from the logging buffer PE
show log Displays log messages PE
show logging Displays the state of logging PE