ECS4660-28F_Management Guide-R03

C HAPTER 24 | System Management Commands
Line
– 932 –
◆ Using the command without specifying a timeout restores the default
setting.
EXAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect This command terminates an SSH, Telnet, or console connection.
SYNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-8)
COMMAND MODE
Privileged Exec
COMMAND USAGE
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
EXAMPLE
Console#disconnect 1
Console#
RELATED COMMANDS
show ssh (1066)
show users (908)
show line This command displays the terminal line’s parameters.
SYNTAX
show line [console | vty]
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
DEFAULT SETTING
Shows all lines
COMMAND MODE
Normal Exec, Privileged Exec