ECS4660-28F_Management Guide-R03

C HAPTER 22 | Using the Command Line Interface
CLI Command Groups
– 880 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
DC (DHCP Server Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
Spanning Tree Configures Spanning Tree settings for the switch 1277
ERPS Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
1305
VLANs Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
1337
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for TCP/UDP traffic
types, IP precedence, and DSCP
1387
Quality of Service Configures Differentiated Services 1407
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration, and
IPv6 MLD snooping
1425
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
1537
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
1561
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and
maintain the links to subscriber CPEs
1603
Domain Name Service Configures DNS services. 1615
Dynamic Host
Configuration Protocol
Configures DHCP client, relay and server functions 1625
Router Redundancy Configures router redundancy to create primary and
backup routers
1713
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
1647
IP Routing Configures static unicast routing, policy-based unicast
routing for BGP, and dynamic unicast routing
1723
Multicast Routing Configures multicast routing protocols PIM-DM and
PIM-SM
1919
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 57: Command Group Index (Continued)
Command Group Description Page