ECS4660-28F_Management Guide-R03

F IGURES
– 78 –
Figure 464: Showing Counters for Errors Found in VRRP Packets 767
Figure 465: Showing Counters for Errors Found in a VRRP Group 768
Figure 466: Configuring RIP 770
Figure 467: Configuring General Settings for RIP 774
Figure 468: Clearing Entries from the Routing Table 775
Figure 469: Adding Network Interfaces to RIP 776
Figure 470: Showing Network Interfaces Using RIP 777
Figure 471: Specifying a Passive RIP Interface 778
Figure 472: Showing Passive RIP Interfaces 778
Figure 473: Specifying a Static RIP Neighbor 779
Figure 474: Showing Static RIP Neighbors 779
Figure 475: Redistributing External Routes into RIP 780
Figure 476: Showing External Routes Redistributed into RIP 781
Figure 477: Setting the Distance Assigned to External Routes 782
Figure 478: Showing the Distance Assigned to External Routes 782
Figure 479: Configuring a Network Interface for RIP 785
Figure 480: Showing RIP Network Interface Settings 786
Figure 481: Showing RIP Interface Settings 787
Figure 482: Showing RIP Peer Information 787
Figure 483: Resetting RIP Statistics 788
Figure 484: Configuring OSPF 789
Figure 485: OSPF Areas 790
Figure 486: Defining OSPF Network Areas Based on Addresses 792
Figure 487: Showing OSPF Network Areas 792
Figure 488: Showing OSPF Process Identifiers 793
Figure 489: AS Boundary Router 795
Figure 490: Configure General Settings for OSPF 796
Figure 491: Showing General Settings for OSPF 797
Figure 492: Adding an NSSA or Stub 798
Figure 493: Showing NSSAs or Stubs 799
Figure 494: OSPF NSSA 799
Figure 495: Configuring Protocol Settings for an NSSA 802
Figure 496: OSPF Stub Area 802
Figure 497: Configuring Protocol Settings for a Stub 804
Figure 498: Displaying Information on NSSA and Stub Areas 805
Figure 499: Route Summarization for ABRs 805