ECS4660-28F_Management Guide-R03

C HAPTER 18 | General IP Routing
Configuring Static Routes
– 753 –
DISPLAYING
ARP STATISTICS
Use the IP > ARP (Show Information) page to display statistics for ARP
messages crossing all interfaces on this router.
CLI REFERENCES
◆ "show ip traffic" on page 1728
PARAMETERS
These parameters are displayed:
WEB INTERFACE
To display ARP statistics:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Statistics.
Figure 451: Displaying ARP Statistics
CONFIGURING STATIC ROUTES
This router can dynamically configure routes to other network segments
using dynamic routing protocols (i.e., RIP, OSPF, BGP). However, you can
also manually enter static routes in the routing table using the IP >
Routing > Static Routes (Add) page. Static routes may be required to
access network segments where dynamic routing is not supported, or can
be set to force the use of a specific route to a subnet, rather than using
dynamic routing. Static routes do not automatically change in response to
Table 51: ARP Statistics
Parameter Description
Received Request Number of ARP Request packets received by the router.
Received Reply Number of ARP Reply packets received by the router.
Sent Request Number of ARP Request packets sent by the router.
Sent Reply Number of ARP Reply packets sent by the router.