ECS4660-28F_Management Guide-R03

C HAPTER 17 | IP Services
Dynamic Host Configuration Protocol
– 724 –
ENABLING THE SERVER
Use the IP Service > DHCP > Server (Configure Global) page to enable the
DHCP Server.
CLI REFERENCES
◆ "service dhcp" on page 1634
PARAMETERS
These parameters are displayed:
◆ DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
WEB INTERFACE
To enable the DHCP server:
1. Click IP Service, DHCP, Server.
2. Select Configure Global from the Step list.
3. Mark the Enabled box.
4. Click Apply.
Figure 427: Enabling the DHCP Server
SETTING EXCLUDED ADDRESSES
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add)
page to specify the IP addresses that should not be assigned to clients.
CLI REFERENCES
◆ "ip dhcp excluded-address" on page 1633
PARAMETERS
These parameters are displayed:
◆ Start IP Address – Specifies a single IP address or the first address in
a range that the DHCP server should not assign to DHCP clients.
◆ End IP Address – The last address in a range that the DHCP server
should not assign to DHCP clients.