ECS4660-28F_Management Guide-R03

C HAPTER 17 | IP Services
Domain Name Service
– 716 –
To show the list domain names:
1. Click IP Service, DNS.
2. Select Show Domain Names from the Action list.
Figure 417: Showing the List of Domain Names for DNS
CONFIGURING A LIST
OF NAME SERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI REFERENCES
◆ "ip name-server" on page 1619
◆ "show dns" on page 1621
COMMAND USAGE
◆ To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see "Configuring General
DNS Service Parameters" on page 713).
◆ When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
◆ If all name servers are deleted, DNS will automatically be disabled. This
is done by disabling the domain lookup status.
PARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the IPv4 or IPv6 address of a
domain name server to use for name-to-address resolution. Up to six IP
addresses can be added to the name server list.
WEB INTERFACE
To create a list name servers:
1. Click IP Service, DNS.
2. Select Add Name Server from the Action list.
3. Enter one name server at a time.