ECS4660-28F_Management Guide-R03

C HAPTER 17 | IP Services
Domain Name Service
– 714 –
COMMAND USAGE
◆ To enable DNS service on this switch, enable domain lookup status, and
configure one or more name servers (see "Configuring a List of Name
Servers" on page 716).
PARAMETERS
These parameters are displayed:
◆ Domain Lookup – Enables DNS host name-to-address translation.
(Default: Disabled)
◆ Default Domain Name – Defines the default domain name appended
to incomplete host names. Do not include the initial dot that separates
the host name from the domain name.
(Range: 1-127 alphanumeric characters)
WEB INTERFACE
To configure general settings for DNS:
1. Click IP Service, DNS.
2. Select Configure Global from the Action list.
3. Enable domain lookup, and set the default domain name.
4. Click Apply.
Figure 415: Configuring General Settings for DNS
CONFIGURING A LIST
OF
DOMAIN NAMES
Use the IP Service > DNS - General (Add Domain Name) page to configure
a list of domain names to be tried in sequential order.
CLI REFERENCES
◆ "ip domain-list" on page 1615
◆ "show dns" on page 1621
COMMAND USAGE
◆ Use this page to define a list of domain names that can be appended to
incomplete host names (i.e., host names passed from a client that are
not formatted with dotted notation).