ECS4660-28F_Management Guide-R03

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 574 –
WEB INTERFACE
To transmit delay-measure messages:
1. Click Administration, CFM.
2. Select Transmit Delay Measure from the Step list.
3. Select an entry from MD Index and MA Index.
4. Specify the source MEP, the target MEP using either its MEP identifier or
MAC address, set the number of times the delay-measure message is
to be sent, the interval, and the timeout.
5. Click Apply.
Figure 315: Transmitting Delay-Measure Messages
DISPLAYING
LOCAL MEPS
Use the Administration > CFM > Show Information (Show Local MEP) page
to show information for the MEPs configured on this device.
CLI REFERENCES
◆ "show ethernet cfm maintenance-points local" on page 1576
PARAMETERS
These parameters are displayed:
◆ MEP ID – Maintenance end point identifier.
◆ MD Name – Maintenance domain name.