ECS4660-28F_Management Guide-R03

C HAPTER 13 | Security Measures
Configuring Port Security
– 422 –
■
Trap and Shutdown: Send an SNMP trap message and disable the
port.
◆ Max MAC Count – The maximum number of MAC addresses that can
be learned on a port. (Range: 0-1024, where 0 means disabled)
The maximum address count is effective when port security is enabled
or disabled.
◆ Current MAC Count – The number of MAC addresses currently
associated with this interface.
◆ MAC Filter – Shows if MAC address filtering has been set under
Security > Network Access (Configure MAC Filter) as described on
page 375.
◆ MAC Filter ID – The identifier for a MAC address filter.
◆ Last Intrusion MAC – The last unauthorized MAC address detected.
◆ Last Time Detected Intrusion MAC – The last time an unauthorized
MAC address was detected.
WEB INTERFACE
To configure port security:
1. Click Security, Port Security.
2. Mark the check box in the Security Status column to enable security,
set the action to take when an invalid address is detected on a port,
and set the maximum number of MAC addresses allowed on the port.
3. Click Apply.
Figure 219: Configuring Port Security