ECS4660-28F_Management Guide-R03

C HAPTER 10 | Class of Service
Layer 2 Queue Settings
– 310 –
CLI REFERENCES
◆ "qos map phb-queue" on page 1399
COMMAND USAGE
◆ Egress packets are placed into the hardware queues according to the
mapping defined by this command.
◆ The default internal PHB to output queue mapping is shown below.
◆ The specified mapping applies to all interfaces.
PARAMETERS
These parameters are displayed:
◆ Port – Specifies a port.
◆ PHB – Per-hop behavior, or the priority used for this router hop.
(Range: 0-7, where 7 is the highest priority)
◆ Queue – Output queue buffer. (Range: 0-7, where 7 is the highest CoS
priority queue)
WEB INTERFACE
To map internal PHB to hardware queues:
1. Click Traffic, Priority, PHB to Queue.
2. Select Configure from the Action list.
3. Select a port.
Table 15: CoS Priority Levels
Priority Level Traffic Type
1 Background
2(Spare)
0 (default) Best Effort
3 Excellent Effort
4 Controlled Load
5 Video, less than 100 milliseconds latency and jitter
6 Voice, less than 10 milliseconds latency and jitter
7Network Control
Table 16: Mapping Internal Per-hop Behavior to Hardware Queues
Per-hop Behavior 0 1 2 3 4 5 6 7
Hardware Queues 2 0 1 3 4 5 6 7