ECS4660-28F_Management Guide-R03

C HAPTER 6 | VLAN Configuration
IEEE 802.1Q VLANs
– 231 –
To show the configuration settings for VLAN groups:
1. Click VLAN, Static.
2. Select Show from the Action list.
Figure 73: Showing Static VLANs
ADDING STATIC
MEMBERS TO VLANS
Use the VLAN > Static pages to configure port members for the selected
VLAN index, interface, or a range of interfaces. Use the menus for editing
port members to configure the VLAN behavior for specific interfaces,
including the mode of operation (Hybrid or 1Q Trunk), the default VLAN
identifier (PVID), accepted frame types, and ingress filtering. Assign ports
as tagged if they are connected to 802.1Q VLAN compliant devices, or
untagged they are not connected to any VLAN-aware devices. Or configure
a port as forbidden to prevent the switch from automatically adding it to a
VLAN via the GVRP protocol.
CLI REFERENCES
◆ "Configuring VLAN Interfaces" on page 1345
◆ "Displaying VLAN Information" on page 1352
PARAMETERS
These parameters are displayed:
Edit Member by VLAN
◆ VLAN – ID of configured VLAN (1-4094).
◆ Interface – Displays a list of ports or trunks.
◆ Port – Port Identifier. (Range: 1-28)
◆ Trunk – Trunk Identifier. (Range: 1-8)
◆ Mode – Indicates VLAN membership mode for an interface.
(Default: Hybrid)
■
Hybrid – Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
■
1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. Note that frames