ECS4660-28F_Management Guide-R03

C HAPTER 6 | VLAN Configuration
IEEE 802.1Q VLANs
– 229 –
◆ Remote VLAN – Reserves this VLAN for RSPAN (see "Configuring
Remote Port Mirroring" on page 188).
◆ L3 Interface – Sets the interface to support Layer 3 configuration, and
reserves memory space required to maintain additional information
about this interface type. This parameter must be enabled before you
can assign an IP address to a VLAN (see "Setting the Switch’s IP
Address (IP Version 4)" on page 691).
Modify
◆ VLAN ID – ID of configured VLAN (1-4094).
◆ VLAN Name – Name of the VLAN (1 to 32 characters).
◆ Status – Enables or disables the specified VLAN.
◆ L3 Interface – Sets the interface to support Layer 3 configuration, and
reserves memory space required to maintain additional information
about this interface type. This parameter must be enabled before you
can assign an IP address to a VLAN.
Show
◆ VLAN ID – ID of configured VLAN.
◆ VLAN Name – Name of the VLAN.
◆ Status – Operational status of configured VLAN.
◆ Remote VLAN – Shows if RSPAN is enabled on this VLAN (see
"Configuring Remote Port Mirroring" on page 188).
◆ L3 Interface – Shows if the interface supports Layer 3 configuration.
WEB INTERFACE
To create VLAN groups:
1. Click VLAN, Static.
2. Select Add from the Action list.
3. Enter a VLAN ID or range of IDs.
4. Enable the Status field to configure the VLAN as operational.
5. Specify whether the VLANs are to be used for remote port mirroring.
6. Enable the L3 Interface field to specify that a VLAN will be used as a
Layer 3 interface.
7. Click Apply.