ECS4660-28F_Management Guide-R03

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 207 –
Figure 51: Configuring Connection Parameters for a Static Trunk
To display trunk connection parameters:
1. Click Interface, Trunk, Static.
2. Select Configure General from the Step list.
3. Select Show Information from the Action list.
Figure 52: Showing Information for Static Trunks
CONFIGURING A
DYNAMIC TRUNK
Use the Interface > Trunk > Dynamic pages to set the administrative key
for an aggregation group, enable LACP on a port, and configure protocol
parameters for local and partner ports, or to set Ethernet connection
parameters.
Figure 53: Configuring Dynamic Trunks
active
links
}
}
dynamically
enabled
configured
members
backup
link