ECS4660-28F_Management Guide-R03

C HAPTER 52 | Multicast Routing Commands
PIM Multicast Routing
– 1953 –
Graft Retry Interval : 3 sec
Max Graft Retries : 3
State Refresh Ori Int : 60 sec
Console#
ipv6 pim
hello-holdtime
This command configures the interval to wait for hello messages from a
neighboring PIM router before declaring it dead. Use the no form to restore
the default value.
SYNTAX
ipv6 pim hello-holdtime seconds
no ipv6 pim hello-interval
seconds - The hold time for PIM hello messages. (Range: 1-65535)
DEFAULT SETTING
105 seconds
COMMAND MODE
Interface Configuration (VLAN)
COMMAND USAGE
The ip pim hello-holdtime should be greater than the value of ipv6 pim
hello-interval.
EXAMPLE
Console(config-if)#ipv6 pim hello-holdtime 210
Console(config-if)#
ipv6 pim
hello-interval
This command configures the frequency at which PIM hello messages are
transmitted. Use the no form to restore the default value.
SYNTAX
ipv6 pim hello-interval seconds
no pimv6 hello-interval
seconds - Interval between sending PIM hello messages.
(Range: 1-65535)
DEFAULT SETTING
30 seconds
COMMAND MODE
Interface Configuration (VLAN)