ECS4660-28F_Management Guide-R03

C HAPTER 52 | Multicast Routing Commands
PIM Multicast Routing
– 1950 –
IPV6 PIM COMMANDS This section describes commands used to configure IPv6 PIM dynamic
multicast routing on the switch.
Table 288: PIM-DM and PIM-SM Multicast Routing Commands
Command Function Mode
Shared Mode Commands
router pim6 Enables IPv6 PIM globally for the router GC
ipv6 pim Enables PIM-DM or PIM-SM on the specified interface IC
ipv6 pim hello-holdtime Sets the time to wait for hello messages from a
neighboring PIM router before declaring it dead
IC
ipv6 pim hello-interval Sets the interval between sending PIM hello messages IC
ipv6 pim
join-prune-holdtime
Configures the hold time for the prune state IC
ipv6 pim lan-prune-delay Informs downstream routers of the delay before it
prunes a flow after receiving a prune request
IC
ipv6 pim override-interval Specifies the time it takes a downstream router to
respond to a lan-prune-delay message
IC
ipv6 pim
propagation-delay
Configures the propagation delay required for a LAN
prune delay message to reach downstream routers
IC
ipv6 pim
trigger-hello-delay
Configures the trigger hello delay IC
show ipv6 pim interface Displays information about interfaces configured for
PIM
NE, PE
show ipv6 pim neighbor Displays information about PIM neighbors NE, PE
PIM-DM Commands
ipv6 pim
graft-retry-interval
Configures the time to wait for a Graft
acknowledgement before resending a Graft message
IC
ipv6 pim
max-graft-retries
Configures the maximum number of times to resend a
Graft message if it has not been acknowledged
IC
ipv6 pim state-refresh
origination-interval
Sets the interval between PIM-DM state refresh control
messages
IC
PIM-SM Commands
ipv6 pim bsr-candidate Configures the switch as a Bootstrap Router (BSR)
candidate
GC
ipv6 pim
register-rate-limit
Configures the rate at which register messages are
sent by the Designated Router (DR)
GC
ipv6 pim register-source Configure the IP source address of a register message
to an address other than the outgoing interface
address of the designated router (DR) leading toward
the rendezvous point (RP)
GC
ipv6 pim rp-address Sets a static address for the rendezvous point GC
ipv6 pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ipv6 pim spt-threshold Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
GC
ipv6 pim dr-priority Sets the priority value for a DR candidate IC
ipv6 pim
join-prune-interval
Sets the join/prune timer IC
clear ipv6 pim bsr rp-set Clears RP entries learned through the BSR PE