ECS4660-28F_Management Guide-R03

C HAPTER 5 | Interface Configuration
Port Configuration
– 186 –
◆ Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆ Oper Speed Duplex – Shows the current speed and duplex mode.
◆ Oper Flow Control – Shows the flow control type used.
◆ MTU Size – The maximum transfer unit (MTU) allowed for layer 2
packets crossing a Gigabit or 10 Gigabit Ethernet port or trunk.
WEB INTERFACE
To display port connection parameters:
1. Click Interface, Port, General.
2. Select Show Information from the Action List.
Figure 31: Displaying Port Information
CONFIGURING LOCAL
PORT MIRRORING
Use the Interface > Port > Mirror page to mirror traffic from any source
port to a target port for real-time analysis. You can then attach a logic
analyzer or RMON probe to the target port and study the traffic crossing
the source port in a completely unobtrusive manner.
Figure 32: Configuring Local Port Mirroring
CLI REFERENCES
◆ "Port Mirroring Commands" on page 1229
COMMAND USAGE
◆ Traffic can be mirrored from one or more source ports to a destination
port on the same switch (local port mirroring as described in this
section), or from one or more source ports on remote switches to a
Source
port(s)
Single
target
port