ECS4660-28F_Management Guide-R03

C HAPTER 51 | IP Routing Commands
Routing Information Protocol (RIP)
– 1737 –
COMMAND MODE
Router Configuration
COMMAND USAGE
All the learned RIP routes may not be copied to the hardware tables in
ASIC for fast data forwarding because of hardware resource limitations.
EXAMPLE
Console(config-router)#maximum-prefix 1024
Console(config-router)#
neighbor This command defines a neighboring router with which this router will
exchange routing information. Use the no form to remove an entry.
SYNTAX
[no] neighbor ip-address
ip-address - IP address of a neighboring router.
DEFAULT SETTING
No neighbors are defined.
COMMAND MODE
Router Configuration
COMMAND USAGE
◆ This command can be used to configure a static neighbor (specifically
for point-to-point links) with which this router will exchange routing
information, rather than relying on broadcast or multicast messages
generated by the RIP protocol.
◆ Use this command in conjunction with the passive-interface command
to control the routing updates sent to specific neighbors.
EXAMPLE
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#
RELATED COMMANDS
passive-interface (1738)