ECS4660-28F_Management Guide-R03

C HAPTER 48 | DHCP Commands
DHCP Server
– 1636 –
COMMAND MODE
DHCP Pool Configuration
COMMAND USAGE
◆ This command identifies a DHCP client to bind to an address specified in
the host command. If both a client identifier and hardware address are
configured for a host address, the client identifier takes precedence
over the hardware address in the search procedure.
◆ BOOTP clients cannot transmit a client identifier. To bind an address to
a BOOTP client, you must associate a hardware address with the host
entry.
EXAMPLE
Console(config-dhcp)#client-identifier text steve
Console(config-dhcp)#
RELATED COMMANDS
host (1638)
default-router This command specifies default routers for a DHCP pool. Use the no form
to remove the default routers.
SYNTAX
default-router address1 [address2]
no default-router
address1 - Specifies the IP address of the primary router.
address2 - Specifies the IP address of an alternate router.
DEFAULT SETTING
None
COMMAND MODE
DHCP Pool Configuration
USAGE GUIDELINES
The IP address of the router should be on the same subnet as the client.
You can specify up to two routers. Routers are listed in order of preference
(starting with address1 as the most preferred router).
EXAMPLE
Console(config-dhcp)#default-router 10.1.0.54 10.1.0.64
Console(config-dhcp)#