ECS4660-28F_Management Guide-R03

C HAPTER 48 | DHCP Commands
DHCP Server
– 1634 –
ip dhcp pool This command configures a DHCP address pool and enter DHCP Pool
Configuration mode. Use the no form to remove the address pool.
SYNTAX
[no] ip dhcp pool name
name - A string or integer. (Range: 1-8 characters)
DEFAULT SETTING
DHCP address pools are not configured.
COMMAND MODE
Global Configuration
USAGE GUIDELINES
◆ After executing this command, the switch changes to DHCP Pool
Configuration
mode, identified by the (config-dhcp)# prompt.
◆ From this mode, first configure address pools for the network interfaces
(using the network command). You can also manually bind an address
to a specific client (with the host command) if required. You can
configure up to 8 network address pools, and up to 32 manually bound
host address pools (i.e., listing one host address per pool). However,
note that any address specified in a host command must fall within the
range of a configured network address pool.
EXAMPLE
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#
RELATED COMMANDS
network (1641)
host (1638)
service dhcp This command enables the DHCP server on this switch. Use the no form to
disable the DHCP server.
SYNTAX
[no] service dhcp
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration