ECS4660-28F_Management Guide-R03

C HAPTER 46 | OAM Commands
– 1608 –
RELATED COMMANDS
show efm oam counters interface (1610)
clear efm oam
event-log
This command clears all entries from the OAM event log for the specified
port.
SYNTAX
clear efm oam event-log [interface-list]
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces; use a
hyphen to designate a range of ports. (Range: 1-28)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear efm oam event-log
Console#
efm oam
remote-loopback
This command starts or stops OAM loopback test mode to the attached
CPE.
SYNTAX
efm oam remote-loopback {start | stop} interface
start - Starts remote loopback test mode.
stop - Stops remote loopback test mode.
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
◆ OAM remote loop back can be used for fault localization and link
performance testing. Statistics from both the local and remote DTE can
be queried and compared at any time during loop back testing.
◆ Use the efm oam remote-loopback start command to start OAM
remote loop back test mode on the specified port. Afterwards, use the