ECS4660-28F_Management Guide-R03

C HAPTER 43 | Multicast Filtering Commands
MLD (Layer 3)
– 1526 –
COMMAND MODE
Interface Configuration (VLAN)
COMMAND USAGE
MLD (including query functions) can be enabled for specific VLAN interfaces
at Layer 3 through the ipv6 mld command.
EXAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld
Console(config-if)#end
Console#show ipv6 mld interface
VLAN 1 : Up
MLD : Enabled
MLD Version : 2
MLD Proxy : Disabled
MLD Unsolicited Report Interval : 400 sec
Robustness Variable : 2
Query Interval : 125 sec
Query Max Response Time : 10 sec
Last Member Query Interval : 1 sec
Querier : ::
Joined Groups :
Static Groups :
Console#
ipv6 mld last-
member-query-
response-interval
This command configures the frequency at which to send MLD group-
specific or MLDv2 group-source-specific query messages in response to
receiving a group-specific or group-source-specific leave message from the
last known active host on the subnet. Use the no form to restore the
default setting.
SYNTAX
ipv6 mld last-member-query-response-interval seconds
no ipv6 mld last-member-query-response-interval
seconds - The frequency at which the switch sends group-specific or
group-source-specific queries upon receipt of a leave message.
(Range: 1-255 seconds)
DEFAULT SETTING
10 (1 second)
COMMAND MODE
Interface Configuration (VLAN)
COMMAND USAGE
When the switch receives an MLD or MLDv2 leave message from a host
that wants to leave a multicast group, source or channel, it sends a
number of group-specific or group-source-specific query messages at