ECS4660-28F_Management Guide-R03

C HAPTER 43 | Multicast Filtering Commands
IGMP (Layer 3)
– 1513 –
The following shows MVR query-related statistics:
Console#show mvr6 domain 1 statistics query
Querier IPv6 Address : FE80::2E0:CFF:FE00:FB/64
Querier Expire Time : 00(h):00(m):30(s)
General Query Received : 10
General Query Sent : 0
Specific Query Received : 2
Specific Query Sent : 0
Number of Reports Sent : 2
Number of Leaves Sent : 0
Console#
IGMP (LAYER 3)
This section describes commands used to configure Layer 3 Internet Group
Management Protocol (IGMP) on the switch.
Table 204: show mvr6 statistics output - display description
Field Description
Interface Shows interfaces attached to the MVR.
Report The number of IGMP membership reports sent from this interface.
Leave The number of leave messages sent from this interface.
G Query The number of general query messages sent from this interface.
G(-S)-S Query The number of group specific or group-and-source specific query messages
sent from this interface.
Table 205: IGMP Commands (Layer 3)
Command Function Mode
ip igmp Enables IGMP for the specified interface IC
ip igmp last-member-
query-interval
Configures the frequency at which to send query
messages in response to receiving a leave message
IC
ip igmp max-resp-interval Configures the maximum host response time IC
ip igmp query-interval Configures frequency for sending host query messages IC
ip igmp robustval Configures the expected packet loss IC
ip igmp static-group Configures the router to be a static member of a
multicast group on the specified VLAN interface
IC
ip igmp version Configures IGMP version used on this interface IC
clear ip igmp group Deletes entries from the IGMP cache PE
show ip igmp groups Displays information for IGMP groups PE
show ip igmp interface Displays multicast information for the specified
interface
PE