ECS4660-28F_Management Guide-R03

C HAPTER 43 | Multicast Filtering Commands
MVR for IPv6
– 1509 –
EXAMPLE
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR Profile Name Start IPv6 Addr. End IPv6 Addr.
-------------------- ------------------------- -------------------------
rd FF00::1 FF00::9
Console#
show mvr6 interface This command shows MVR configuration settings for interfaces attached to
the MVR VLAN.
SYNTAX
show mvr6 [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Displays configuration settings for all attached interfaces.
COMMAND MODE
Privileged Exec
EXAMPLE
The following displays information about the interfaces attached to the
MVR VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- -------------------------
Eth1/ 1 Source Active/Up
Eth1/ 2 Receiver Active/Up Disabled FF00::1(VLAN2)
Console#
Table 201: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR status
for receiver ports is “ACTIVE” only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the receiver
VLAN.