ECS4660-28F_Management Guide-R03

C HAPTER 43 | Multicast Filtering Commands
MVR for IPv6
– 1505 –
leave multicast groups using the standard rules for multicast filtering
(see "MLD Snooping Commands" on page 1469).
◆ Receiver ports can belong to different VLANs, but should not be
configured as a member of the MVR VLAN. Also, note that VLAN
membership for MVR receiver ports cannot be set to access mode (see
the switchport mode command).
◆ One or more interfaces may be configured as MVR source ports. A
source port is able to both receive and send data for multicast groups
which it has joined through the MVR6 protocol or which have been
assigned through the mvr6 vlan group command.
All source ports must belong to the MVR6 VLAN.
Subscribers should not be directly connected to source ports.
◆ The same port cannot be configured as a source port in one MVR
domain and as a receiver port in another domain.
EXAMPLE
The following configures one source port and several receiver ports on the
switch.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr6 domain 1 type source
Console(config-if)#exit
Console(config)#interface ethernet 1/6
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#exit
Console(config)#interface ethernet 1/7
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#
mvr6 vlan group This command statically binds a multicast group to a port which will receive
long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
SYNTAX
[no] mvr6 domain domain-id vlan vlan-id group ip-address
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4094)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IPv6 address specified for an MVR multicast group.
This parameter must be a full IPv6 address including the network
prefix and host address bits.
DEFAULT SETTING
No receiver port is a member of any configured multicast group.