ECS4660-28F_Management Guide-R03

C HAPTER 40 | VLAN Commands
Configuring MAC Based VLANs
– 1378 –
mac-vlan This command configures MAC address-to-VLAN mapping. Use the no form
to remove an assignment.
SYNTAX
mac-vlan mac-address mac-address vlan vlan-id [priority priority]
no mac-vlan mac-address {mac-address | all}
mac-address – The source MAC address to be matched. Configured
MAC addresses can only be unicast addresses. The MAC address
must be specified in the format xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
vlan-id – VLAN to which the matching source MAC address traffic is
forwarded. (Range: 1-4094)
priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ The MAC-to-VLAN mapping applies to all ports on the switch.
◆ Source MAC addresses can be mapped to only one VLAN ID.
◆ Configured MAC addresses cannot be broadcast or multicast addresses.
◆ When MAC-based, IP subnet-based, and protocol-based VLANs are
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
EXAMPLE
The following example assigns traffic from source MAC address 00-00-00-
11-22-33 to VLAN 10.
Console(config)#mac-vlan mac-address 00-00-00-11-22-33 vlan 10
Console(config)#
show mac-vlan This command displays MAC address-to-VLAN assignments.
COMMAND MODE
Privileged Exec
COMMAND USAGE
Use this command to display MAC address-to-VLAN mappings.