ECS4660-28F_Management Guide-R03

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 137 –
Show Candidate Shows candidate members 520
Show Member Shows cluster switch member; managed switch members 522
ERPS Ethernet Ring Protection Switching 523
Configure Global Activates ERPS globally 527
Configure Domain 528
Add Creates an ERPS ring 528
Show Shows list of configured ERPS rings, status, and settings 528
Configure Details Configures ring parameters 528
Configure Operation Blocks a ring port using Forced Switch or Manual Switch
commands
544
CFM Connectivity Fault Management 548
Configure Global Configures global settings, including administrative status, cross-
check start delay, link trace, and SNMP traps
551
Configure Interface Configures administrative status on an interface 555
Configure MD Configure Maintenance Domains 555
Add Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and
the MIP creation method
555
Configure Details Configures the archive hold time and fault notification settings 555
Show Shows list of configured maintenance domains 555
Configure MA Configure Maintenance Associations 560
Add Defines a unique CFM service instance, identified by its parent MD,
the MA index, the VLAN assigned to the MA, and the MIP creation
method
560
Configure Details Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal
parameters
560
Show Shows list of configured maintenance associations 560
Configure MEP Configures Maintenance End Points 565
Add Configures MEPs at the domain boundary to provide management
access for each maintenance association
565
Show Shows list of configured maintenance end points 565
Configure Remote MEP Configures Remote Maintenance End Points 567
Add Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
567
Show Shows list of configured remote maintenance end points 567
Transmit Link Trace Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node
569
Transmit Loopback Sends loopback messages to isolate connectivity faults by
requesting a target node to echo the message back to the source
571
Transmit Delay Measure Sends periodic delay-measure requests to a specified MEP within
a maintenance association
572
Table 6: Switch Main Menu (Continued)
Menu Description Page