ECS4660-28F_Management Guide-R03

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 134 –
Add Rule Configures packet filtering based on IP or MAC addresses and
other packet attributes
395
Show Rule Shows the rules specified for an ACL 395
Configure Interface 408
Configure Binds a port to the specified ACL and time range 408
Show Hardware Counters Shows statistics for ACL hardware counters 409
ARP Inspection 410
Configure General Enables inspection globally, configures validation of additional
address components, and sets the log rate for packet inspection
411
Configure VLAN Enables ARP inspection on specified VLANs 413
Configure Interface Sets the trust mode for ports, and sets the rate
limit for packet inspection
415
Show Information
Show Statistics Displays statistics on the inspection process 416
Show Log Shows the inspection log list 417
IP Filter 418
Add Sets IP addresses of clients allowed management access via the
web, SNMP, and Telnet
418
Show Shows the addresses to be allowed management access 418
Port Security Configures per port security, including status, response for
security breach, and maximum allowed MAC addresses
420
Port Authentication IEEE 802.1X 423
Configure Global Enables authentication and EAPOL pass-through 424
Configure Interface Sets authentication parameters for individual ports 425
Show Statistics Displays protocol statistics for the selected port 429
DoS Protection Protects against Denial-of-Service attacks 431
IP Source Guard Filters IPv4 traffic based on static entries in the IP Source Guard
table, or dynamic entries in the DHCPv4 Snooping table
432
Port Configuration Enables IP source guard and selects filter type per port 433
Static Binding 435
Add Adds a static addresses to the source-guard binding table 435
Show Shows static addresses in the source-guard binding table 435
Dynamic Binding Displays the source-guard binding table for a selected interface 437
IPv6 Source Guard Filters IPv6 traffic based on static entries in the IP Source Guard
table, or dynamic entries in the DHCP Snooping table
438
Port Configuration Enables IPv6 source guard and selects filter type per port 438
Static Binding 440
Add Adds a static addresses to the source-guard binding table 440
Show Shows static addresses in the source-guard binding table 440
Dynamic Binding Displays the source-guard binding table for a selected interface 443
Table 6: Switch Main Menu (Continued)
Menu Description Page