ECS4660-28F_Management Guide-R03

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 129 –
Show Display configured primary and community VLANs 239
Add Community VLAN Associates a community VLAN with a primary VLAN 240
Show Community VLAN Shows the community VLANs associated with a primary VLAN 240
Configure Interface Sets the private VLAN interface type, and associates the
interfaces with a private VLAN
242
Tunnel IEEE 802.1Q (QinQ) Tunneling 243
Configure Global Sets tunnel mode for the switch 247
Configure Interface Sets the tunnel mode for any participating interface 250
Protocol 251
Configure Protocol 252
Add Creates a protocol group, specifying supported protocols 252
Show Shows configured protocol groups 252
Configure Interface 253
Add Maps a protocol group to a VLAN 253
Show Shows the protocol groups mapped to each VLAN 253
IP Subnet 256
Add Maps IP subnet traffic to a VLAN 256
Show Shows IP subnet to VLAN mapping 256
MAC-Based 258
Add Maps traffic with specified source MAC address to a VLAN 258
Show Shows source MAC address to VLAN mapping 258
Translation 259
Add Maps VLAN IDs between the customer and service provider 259
Show Displays the configuration settings for VLAN translation 259
MAC Address 263
Learning Status Enables MAC address learning on selected interfaces 263
Static 265
Add Configures static entries in the address table 265
Show Displays static entries in the address table 265
Dynamic
Configure Aging Sets timeout for dynamically learned entries 267
Show Dynamic MAC Displays dynamic entries in the address table 268
Clear Dynamic MAC Removes any learned entries from the forwarding database and
clears the transmit and receive counts for any static or system
configured entries
269
Spanning Tree 271
Loopback Detection Configures Loopback Detection parameters 274
Table 6: Switch Main Menu (Continued)
Menu Description Page