ECS4660-28F_Management Guide-R03

C HAPTER 31 | Interface Commands
Transceiver Threshold Configuration
– 1209 –
DEFAULT SETTING
High Alarm: 75.00 °C
HIgh Warning: 70.00
°C
Low Alarm: -123.00
°C
Low Warning: 0.00
°C
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
◆ Refer to the Command Usage section under the transceiver-threshold
current command for more information on configuring transceiver
thresholds.
◆ Trap messages enabled by the transceiver-threshold-monitor command
are sent to any management station configured by the snmp-server
host command.
EXAMPLE
The following example sets alarm thresholds for the transceiver
temperature at port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold temperature low-alarm 97
Console(config-if)#transceiver-threshold temperature high-alarm -83
Console#
transceiver-
threshold tx-power
This command sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or warning
message.
SYNTAX
transceiver-threshold tx-power {high-alarm | high-warning |
low-alarm | low-warning} threshold-value
high-alarm – Sets the high power threshold for an alarm message.
high-warning – Sets the high power threshold for a warning
message.
low-alarm – Sets the low power threshold for an alarm message.
low-warning – Sets the low power threshold for a warning
message.
threshold-value – The power threshold of the transmitted signal.
(Range: -9999 - 9999 in units of 0.01 dBm)
DEFAULT SETTING
High Alarm: -9.00 dBm
HIgh Warning: -9.50 dBm