ECS4660-28F_Management Guide-R03

C HAPTER 31 | Interface Commands
Interface Configuration
– 1188 –
Interface Configuration
interface This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface.
SYNTAX
[no] interface interface
interface
craft - Management port on the front panel.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-8)
vlan vlan-id (Range: 1-4094)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
The craft interface is provided as an out-of-band management connection
which is isolated from all other ports on the switch. This interface must first
be configured with an IPv4 or IPv6 address before a connection can be
made through Telnet, SSH, or HTTP.
transceiver-threshold
rx-power
Sends a trap when the power level of the received
signal power falls outside the specified thresholds
IC
transceiver-threshold
temperature
Sends a trap when the transceiver temperature falls
outside the specified thresholds
IC
transceiver-threshold
tx-power
Sends a trap when the power level of the transmitted
signal power outside the specified thresholds
IC
transceiver-threshold
voltage
Sends a trap when the transceiver voltage falls outside
the specified thresholds
IC
show interfaces
transceiver
Displays the temperature, voltage, bias current,
transmit power, and receive power
PE
show interfaces
transceiver-threshold
Displays the alarm/warning thresholds for
temperature, voltage, bias current, transmit power,
and receive power
PE
Table 133: Interface Commands (Continued)
Command Function Mode