ECS4660-28F_Management Guide-R03

C HAPTER 30 | Access Control Lists
MAC ACLs
– 1177 –
◆ An ACL can contain up to 128 rules.
EXAMPLE
Console(config)#access-list mac jerry
Console(config-mac-acl)#
RELATED COMMANDS
permit, deny (1177)
mac access-group (1179)
show mac access-list (1180)
permit, deny
(MAC ACL)
This command adds a rule to a MAC ACL. The rule filters packets matching
a specified MAC source or destination address (i.e., physical layer address),
or Ethernet protocol type. Use the no form to remove a rule.
SYNTAX
{permit | deny}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
no {permit | deny}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
N OTE : The default is for Ethernet II packets.
{permit | deny} tagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
no {permit | deny} tagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{permit | deny} untagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype
protocol [protocol-bitmask]]
[time-range time-range-name]
no {permit | deny} untagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype protocol [protocol-bitmask]]