ECS4510 Series CLI Reference Guide-R03

Chapter 24 | Multicast Filtering Commands
IGMP Snooping
– 646 –
priority - The CoS priority assigned to all multicast traffic. (Range: 0-7, where
7 is the highest priority)
Default Setting
2
Command Mode
Global Configuration
Command Usage
This command can be used to set a high priority for low-latency multicast traffic
such as a video-conference, or to set a low priority for normal multicast traffic not
sensitive to latency.
Example
Console(config)#ip igmp snooping priority 6
Console(config)#
Related Commands
show ip igmp snooping (661)
ip igmp snooping
proxy-reporting
This command enables IGMP Snooping with Proxy Reporting. Use the no form to
restore the default setting.
Syntax
[no] ip igmp snooping proxy-reporting
ip igmp snooping vlan vlan-id proxy-reporting {enable | disable}
no ip igmp snooping vlan vlan-id proxy-reporting
vlan-id - VLAN ID (Range: 1-4093)
enable - Enable on the specified VLAN.
disable - Disable on the specified VLAN.
Default Setting
Global: Enabled
VLAN: Based on global setting
Command Mode
Global Configuration
Command Usage
◆ When proxy reporting is enabled with this command, the switch performs
“IGMP Snooping with Proxy Reporting” (as defined in DSL Forum TR-101, April
2006), including last leave, and query suppression. Last leave sends out a proxy
query when the last member leaves a multicast group, and query suppression