ECS4510 Series CLI Reference Guide-R03

Chapter 2 | Using the Command Line Interface
Entering Commands
– 87 –
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to “Console(config)#” which
gives you access privilege to all Global Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
Table 4: Configuration Command Modes
Mode Command Prompt Page
Access Control
List
access-list arp
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac
Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl)
393
372
372
379
379
386
CFM ethernet cfm domain Console(config-ether-cfm) 773
Class Map class-map Console(config-cmap) 624
ERPS erps domain Console(config-erps) 534
Interface interface {ethernet port | port-channel id |
vlan id}
Console(config-if ) 400
Line line {console | vty} Console(config-line) 138
MSTP spanning-tree mst-configuration Console(config-mstp) 508
Policy Map policy-map Console(config-pmap) 628
Router router rip Console(config-router) 899
Time Range time-range Console(config-time-range) 172
VLAN vlan database Console(config-vlan) 569