ECS4510 Series CLI Reference Guide-R03

Chapter 29 | DHCP Commands
DHCP Relay
– 840 –
◆ When issuing the no ipv6 dhcp relay destination command without any
arguments, the switch will delete all configured destination addresses and
disable DHCP for IPv6 relay for all VLANs.
EXAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 dhcp relay destination 2001:0DB8:3000:3000::42
Console(config-if)#
show ipv6 dhcp relay
destination
This command shows the destination addresses or VLAN to which client messages
are forwarded for DHCP relay service.
Syntax
show ipv6 dhcp relay destination interface [vlan vlan-id]
vlan-id - ID of configured VLAN. (Range: 1-4094, no leading zeroes)
Command Mode
Privileged Exec
Example
Console#show ipv6 dhcp relay destination interface vlan 1
DHCP relay destination :
VLAN 1 :
Unicast : 2001:DB8:3000:3000::42
Console#
show ip dhcp This command displays a brief list of .
Command Mode
Privileged Exec
Example
show ip dhcp poolThis command
Syntax
show ip dhcp [host | network]
host - Shows detailed settings for host device pools.network - Shows
detailed settings for network pools.
Default Setting
None