ECS4510 Series Release Note

14
Fix
For looging send mail, when the hour/min/sec is in single digit, the
preceding 0 is dropped
15
Fix
Diagnostics LED should be Blinking Amber while a system fan has
failed.
16
Fix
For stacking, the DUT doesn't learning the mac-address when
stacking the 8 units and snmpwalk overnight
17
Fix
No setting to adjust daylight saving at web GUI
18
Fix
PVID may be configured to a VLAN which a port does not join on
hybrid or trunk mode. If the VLAN doesn't exist, the VLAN will be
auto created.
19
Fix
When change power from main to redundant power, exception occurs
20
Fix
Can't see the RSPAN source port configuration on unit 2 when
stacking
21
Fix
EPLD version in "show version" is incorrect
22
Fix
For stacking, The DUT will dump error message and automatically
reboot after 10 mins when copy startup to running.
23
Fix
IGMPSNP entry count error
24
Fix
Switch generates TC when disconnect the device from operational
edge port
25
Fix
Fluctuated link status of 10G port causes CPU 100% usage
26
Fix
snmpwalk "lldpXMedLocLocationInfo" will get error
27
Fix
All port statistics chart on web interface shows 0 packet in Broadcast
Packets
28
Fix
Traffic segmentation: not work with hot removal/insertion
29
Fix
Displaying wrong info about MAC ACL hardware counters on web
interface
30
Fix
Failed to write dynamic learned DHCPSNP binding entries to flash
31
Fix
For stacking, during delete the 4K VLANS on 48 ports, users can not
manage the DUT from telnet/web/snmp.
32
Fix
Traffic segmentation: not working with hot removal/insertion
33
Fix
For stacking, cannot renumber
34
Fix
Passive DAC cable causes CPU rising in stacking mode
35
Fix
VLAN: VLAN range 1~4093 is wrong, while featureList shows
1~4094
36
Fix
For stacking, DUT auto reboot after adding 4K VLAN.
37
Fix
Power status is not shown when executing "show system" in a
standalone unit where unit_id !=1
38
Fix
No IP DHCP snooping information option circuit-id on one port, then
causes exception
39
Fix
SWDRV_MONITOR thread spends some CPU time every second
40
Fix
For stacking, master unit can't correctly show all units' information