ECS4510 Series CLI Reference Guide-R03

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 90 –
Congestion C ontrol Sets the input/output rate limits, traffic storm thresholds, and
thresholds for broadcast and multicast storms which can be
used to trigger configured rate limits or to shut down a port.
461
Loopback Detection Detects general loopback conditions caused by hardware
problems or faulty protocol settings
479
UniDirectional Link
Detection
Detect and disables unidirectional links 485
Address Table Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
493
Spanning Tree Configures Spanning Tree settings for the switch 501
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service
provider networks
531
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures private VLANs,
protocol VLANs, voice VLANs, and QinQ tunneling
563
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for DSCP
609
Quality of Service Configures Differentiated Services 623
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration, and IPv6 MLD
snooping
643
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
741
Connectivity Fault
Management
Configures connectivity monitoring using continuity check
messages, fault verification through loopback messages, and
fault isolation by examining end-to-end connections
between Provider Edge devices or between Customer Edge
devices
767
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and maintain
the links to subscriber CPEs
809
Domain Name Service Configures DNS services. 821
Dynamic Host
Configuration Protocol
Configures DHCP client, relay and server functions 829
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
843
IP Routing Configures static and dynamic unicast routing 893
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
* ECS4510-28P/52P
Table 6: Command Group Index (Continued)
Command Group Description Page