ECS4510 Series CLI Reference Guide-R03

Chapter 11 | Interface Commands
Interface Configuration
– 409 –
◆ To force operation to the speed and duplex mode specified in a speed-duplex
command, use the no negotiation command to disable auto-negotiation on
the selected interface.
◆ When using the negotiation command to enable auto-negotiation, the optimal
settings will be determined by the capabilities command. To set the speed/
duplex mode under auto-negotiation, the required mode must be specified in
the capabilities list for an interface.
Example
The following example configures port 5 to 100 Mbps, half-duplex operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation (407)
capabilities (402)
clear counters This command clears statistics on an interface.
Syntax
clear counters interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base value for
displayed statistics to zero for the current management session. However, if you log
out and back into the management interface, the statistics displayed will show the
absolute value accumulated since the last power reset.