ECS4510 Series Web Management Guide-R03

Chapter 17 | General IP Routing
Configuring Static Routes
– 652 –
◆ Next Hop – IP address of the next router hop used for this route.
◆ Distance – An administrative distance indicating that this route can be
overridden by dynamic routing information if the distance of the dynamic
route is less than that configured for the static route. Note that the default
administrative distances used by the dynamic unicast routing protocols is 120
for RIP. (Range: 1-255, Default: 1)
Web Interface
To configure static routes:
1. Click IP, Routing, Static Routes.
2. Select Add from the Action List.
3. Enter the destination address, subnet mask, and next hop router.
4. Click Apply.
Figure 429: Configuring Static Routes
To display static routes:
1. Click IP, Routing, Static Routes.
2. Select Show from the Action List.
Figure 430: Displaying Static Routes