Software Release Note

41
Fix
When changing power between main power supply and redundant
power supply, PoE would not provide power
42
Fix
When master of stacked switch executes "copy startup running", it
hangs and slave reboots
43
Fix
It takes long time to save/show config, when ECS4510 series stack
with 8 units
44
Fix
Watchdog reboots system while show running configuration
45
Fix
When stacking, the unit ID is duplicated after assign unit id
46
Fix
1Q VLAN: DUT cannot show all maximum VLANs, and it exits CLI
session automatically.
47
Fix
When stacking, DUT will hang at hot insertion phase and cause
software watchdog timeout reboot after 10 minutes
48
Fix
When stacking, FS synchronizing run time takes long time and
watchdog will time out which causes reboot
49
Fix
Can't change admin password via web interface
50
Fix
L2Mgmt: Save the configaration and reboot, the alarm rising from
process CPU will become default.
51
Fix
Software checking port up/down spends more time
52
Fix
When stacking, the DUT dumps an error message "[MSL-ERROR]
msl_intf_stacking_isc_send[2833]: Send ISC fail" during overnight
test
53
Fix
MLDv2: Can't change query interval by SNMP.
54
Fix
RMON: Input snmpset command by net-snap, the system shows
exception log.
55
Fix
When removing spanning tree MSTP mode then switch will hang in
boot process
56
Fix
When synchronizing the runtime, open telnet session and call "dir",
system will hang and cause SW watchdog timeout.
57
Fix
Traffic segmentation can't stop communication between downlink
port of salve units
58
Fix
Applying "no lldp med-tlv ext-poe" to slave unit but it's applied to
master unit