ECS4510-28F_Quick Start Guide-R03

Quick Start Guide

– 3 –

3. Ground the Switch Before powering on the switch, ground the switch to earth.

Ensure the rack on which the switch is to be mounted is properly grounded and in

compliance with ETSI ETS 300 253. Verify that there is a good electrical connection

to the grounding point on the rack (no paint or isolating surface treatment.).

Caution:

The earth connection must not be removed unless all supply

connections have been disconnected

4. Connect the Power For the AC models , connect the switch to an AC power source that can provide the

following:

◆ ECS4510-28T: 100 to 240 V, 50-60 Hz, 1.5 A

◆ ECS4510-28P: 100 to 240 V, 50-60 Hz, 10 A

◆ ECS4510-28F: 100 to 240 V, 50-60 Hz, 2 A

◆ ECS4510-52T: 100-240 VAC, 50-60 Hz, 2 A

◆ ECS4510-52P: 50-60 Hz; 100-127 VAC, 12 A; 200-240 VAC, 6 A

Caution:

Before connecting the switch to AC power, the grounding terminal

screw, on the switch rear panel, must be permanently connected to earth.

Connect a grounding wire and lug to the dual-hole grounding point on the switch rear panel,

then to rack ground.