Web Management Guide-R03

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 47 –
Main Menu Using the onboard web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from this program.
Table 4: Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information
66
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
67
IP Sets the IPv4 address for management access
431
Capability Enables support for jumbo frames;
shows the bridge extension parameters
68,
69
File
71
Copy Allows the transfer and copying files
71
Set Startup Sets the startup file
74
Show Shows the files stored in flash memory; allows deletion of files
74
Automatic Operation Code Upgrade Automatically upgrades operation code if a newer version is
found on the server
75
Time
79
Configure General
Manual Manually sets the current time
79
SNTP Configures SNTP polling interval
80
NTP Configures NTP authentication parameters
81
Configure Time Server Configures a list of SNTP servers
82
Configure SNTP Server Sets the IP address for SNTP time servers
82
Add NTP Server Adds NTP time server and index of authentication key
83
Show NTP Server Shows list of configured NTP time servers
83
Add NTP Authentication Key Adds key index and corresponding MD5 key
84
Show NTP Authentication Key Shows list of configured authentication keys
84
Configure Time Zone Sets the local time zone for the system clock
85
Console Sets console port connection parameters
86
Telnet Sets Telnet connection parameters
88
CPU Utilization Displays information on CPU utilization
90
Memory Status Shows memory utilization parameters
91