Web Management Guide-R03

Chapter 4 | Interface Configuration
Port Configuration
– 111 –
Web Interface
To test the cable attached to a port:
1. Click Interface, Port, Cable Test.
2. Click Test for any port to start the cable test.
Figure 41: Performing Cable Tests
Configuring
Port Isolation
Port Isolation can be used to restrict the traffic types or protocol types allowed to
pass between specified ports. Isolating traffic to the required uplink and downlink
ports can prevent certain types of malicious attacks, and can also reduce the overall
amount of traffic crossing the switch.
Enabling Port Isolation Globally
Use the Interface > Port > Isolation (Configure Global) page to enable or disable
port isolation globally on the switch.
Parameters
These parameters are displayed:
◆ Port-Isolation Global Status – Enables or disables port isolation globally on
the switch. (Default: Disabled)
Web Interface
To enable or disable port isolation on the switch:
1. Click Interface, Port, Isolation.
2. Select Configure Global from the Step list.