Web Management Guide-R01
Table Of Contents
- How to Use This Guide
- Contents
- Figures
- Tables
- Getting Started
- Web Configuration
- Using the Web Interface
- Basic Management Tasks
- Displaying System Information
- Displaying Hardware/Software Versions
- Configuring Support for Jumbo Frames
- Displaying Bridge Extension Capabilities
- Managing System Files
- Setting the System Clock
- Configuring the Console Port
- Configuring Telnet Settings
- Displaying CPU Utilization
- Configuring CPU Guard
- Displaying Memory Utilization
- Resetting the System
- Interface Configuration
- VLAN Configuration
- Address Table Settings
- Spanning Tree Algorithm
- Congestion Control
- Class of Service
- Quality of Service
- VoIP Traffic Configuration
- Security Measures
- AAA (Authentication, Authorization and Accounting)
- Configuring User Accounts
- Web Authentication
- Network Access (MAC Address Authentication)
- Configuring HTTPS
- Configuring the Secure Shell
- Access Control Lists
- Filtering IP Addresses for Management Access
- Configuring Port Security
- Configuring 802.1X Port Authentication
- DoS Protection
- DHCP Snooping
- DHCPv6 Snooping
- ND Snooping
- IPv4 Source Guard
- IPv6 Source Guard
- ARP Inspection
- Application Filter
- Basic Administration Protocols
- Configuring Event Logging
- Link Layer Discovery Protocol
- Simple Network Management Protocol
- Configuring Global Settings for SNMP
- Setting Community Access Strings
- Setting the Local Engine ID
- Specifying a Remote Engine ID
- Setting SNMPv3 Views
- Configuring SNMPv3 Groups
- Configuring Local SNMPv3 Users
- Configuring Remote SNMPv3 Users
- Specifying Trap Managers
- Creating SNMP Notification Logs
- Showing SNMP Statistics
- Remote Monitoring
- Switch Clustering
- Setting a Time Range
- Ethernet Ring Protection Switching
- OAM Configuration
- UDLD Configuration
- LBD Configuration
- Multicast Filtering
- Overview
- Layer 2 IGMP (Snooping and Query for IPv4)
- Configuring IGMP Snooping and Query Parameters
- Specifying Static Interfaces for a Multicast Router
- Assigning Interfaces to Multicast Services
- Setting IGMP Snooping Status per Interface
- Filtering IGMP Packets on an Interface
- Displaying Multicast Groups Discovered by IGMP Snooping
- Displaying IGMP Snooping Statistics
- Filtering and Throttling IGMP Groups
- MLD Snooping (Snooping and Query for IPv6)
- Configuring MLD Snooping and Query Parameters
- Setting Immediate Leave Status for MLD Snooping per Interface
- Specifying Static Interfaces for an IPv6 Multicast Router
- Assigning Interfaces to IPv6 Multicast Services
- Filtering MLD Query Packets on an Interface
- Showing MLD Snooping Groups and Source List
- Displaying MLD Snooping Statistics
- Filtering and Throttling MLD Groups
- Multicast VLAN Registration for IPv4
- IP Tools
- IP Configuration
- General IP Routing
- IP Services
- Appendices
Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 63 –
Remote Loopback Performs a loopback test on the specified port 500
UDLD UniDirectional Link Detection 503
Configure Global Configures the message probe interval, detection interval, and recovery
interval
504
Configure Interface Enables UDLD and aggressive mode which reduces the shut-down
delay after loss of bidirectional connectivity is detected
505
Show Information Displays UDLD neighbor information, including neighbor state,
expiration time, and protocol intervals
507
LBD Loopback Detection 508
Configure Global Enables loopback detection globally, specifies the interval at which to
transmit control frames, specifies the interval to wait before releasing
an interface from shutdown state, specifies response to detect
loopback, and traps to send
509
Configure Interface Enables loopback detection per interface 510
Tools
Ping Sends ICMP echo request packets to another node on the network 463
Trace Route Shows the route packets take to the specified
destination
464
ARP Shows entries in the Address Resolution Protocol cache 466
IP 595
General
Routing Interface
Add Address Configures an IP interface for a VLAN 595
Show Address Shows the IP interfaces assigned to a VLAN 595
Routing
Static Routes 624
Add Configures static routing entries 624
Show Shows static routing entries 624
Routing Table Shows all routing entries, including local, static and dynamic routes 625
IPv6 Configuration 599
Configure Global Sets an IPv6 default gateway for traffic with no known next hop 599
Configure Interface Configures IPv6 interface address using auto-configuration or link-local
address, and sets related protocol settings
600
Configure Neighbor Configures static IPv6 neighbor addresses 605
Add IPv6 Address Adds an global unicast, EUI-64, or link-local IPv6 address to an interface 606
Configure IPv6 ND Prefix Configures IPv6 prefixes to include in router advertisements 609
Show IPv6 Address Show the IPv6 addresses assigned to an interface 611
Show IPv6 Neighbor Cache Displays information in the IPv6 neighbor discovery cache 612
Table 4: Switch Main Menu (Continued)
Menu Description Page