Web Management Guide-R01

Table Of Contents
Chapter 12
| Security Measures
DHCPv6 Snooping
– 365 –
Max Binding – Sets the maximum number of entries which can be stored in
the binding database for an interface. (Range: 1-5; Default: 5)
Current Binding – Shows the maximum number of entries which can be stored
in the binding database for an interface.
Web Interface
To configure the trust status and maximum bindings for DHCPv6 Snooping:
1. Click Security, DHCP Snooping6.
2. Select Configure Interface from the Step list.
3. Set any interfaces within the local network or firewall to trusted.
4. Set the maximum number of entries which can stored for an interface.
5. Click Apply
Figure 227: Configuring the Trust Sate for DHCPv6 Snooping
Displaying DHCPv6
Snooping Binding
Information
Use the Security > DHCP Snooping6 (Show Information – Binding) page to display
entries in the binding table.
Parameters
These parameters are displayed:
Link-layer Address – IPv6 link-layer address associated with the entry.
IPv6 Address – IPv6 address corresponding to the client.
Lifetime – The time (number of seconds) for which this IPv6 address is leased
to the client.
VLAN – VLAN to which this entry is bound.
Interface – Port or trunk to which this entry is bound.