CLI Reference Guide-R01

Chapter 2 | Using the Command Line Interface
Entering Commands
– 77 –
power-save Shows the power saving information
pppoe Displays PPPoE configuration
privilege Shows current privilege level
process Device process
protocol-vlan Protocol-VLAN information
public-key Public key information
qos Quality of Service
queue Priority queue information
radius-server RADIUS server information
reload Shows the reload settings
rmon Remote monitoring information
rspan Display status of the current RSPAN configuration
running-config Information on the running configuration
sflow Shows the sflow information
snmp Simple Network Management Protocol configuration and
statistics
snmp-server Displays SNMP server configuration
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
ssh Secure shell server connections
startup-config Startup system configuration
subnet-vlan IP subnet-based VLAN information
system System information
tacacs-server TACACS server information
tech-support Technical information
time-range Time range
traffic-segmentation Traffic segmentation information
twamp TWAMP configuration, statistics and session information
udld Displays UDLD information
upgrade Shows upgrade information
users Information about users logged in
version System hardware and software versions
vlan Shows virtual LAN settings
vlan-translation VLAN translation information
voice Shows the voice VLAN information
watchdog Displays watchdog status
web-auth Shows web authentication configuration
Console#show
The command “show interfaces ?” will display the following information:
Console#show interfaces ?
brief Shows brief interface description
counters Interface counters information
history Historical sample of interface counters information
protocol-vlan Protocol-VLAN information
status Shows interface status
switchport Shows interface switchport information
transceiver Interface of transceiver information
transceiver-threshold Interface of transceiver-threshold information
Console#
Show commands which display more than one page of information (e.g., show
running-config) pause and require you to press the [Space] bar to continue
displaying one more page, the [Enter] key to display one more line, or the [a] key to
display the rest of the information without stopping. You can press any other key to
terminate the display.