CLI Reference Guide-R01

Chapter 25 | Multicast Filtering Commands
MVR for IPv4
– 722 –
port-channel channel-id (Range: 1-28)
vlan vlan-id - VLAN identifier (Range: 1-4094)
Command Mode
Privileged Exec
Example
Console#clear mvr statistics
Console#
show mvr This command shows information about MVR domain settings, including MVR
operational status, the multicast VLAN, the current number of group addresses, and
the upstream source IP address.
Syntax
show mvr [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all MVR domains.
Command Mode
Privileged Exec
Example
The following shows the MVR settings:
Console#show mvr
MVR Proxy Switching : Enabled
MVR Robustness Value : 1
MVR Proxy Query Interval : 125(sec.)
MVR Source Port Mode : Always Forward
MVR Domain : 1
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
MVR Current Learned Groups : 10
MVR Upstream Source IP : 192.168.0.3
.
.
.
Table 139: show mvr - display description
Field Description
MVR Proxy Switching Shows if MVR proxy switching is enabled
MVR Robustness Value Shows the number of reports or query messages sent when proxy
switching is enabled