CLI Reference Guide-R01

Chapter 1 | Initial Switch Configuration
Automatic Installation of Operation Code and Configuration Settings
– 61 –
Download the corresponding license file as shown in the following example using
the file type number “21”. Note that the license file is named according to the
device MAC address. The network ports will be automatically activated within two
minutes after successful installation.
Console#copy tftp file
TFTP server IP address: 192.168.1.9
Choose file type:
1. config; 2. opcode: 21
Source file name: ecs4130_cc37abbc4ffa.lic
Flash programming started.
Flash programming completed.
Success.
Console#
To verify that a port license is installed on the switch, enter the show interfaces
brief command from the console port.
Console#show interfaces brief
Interface Name Status PVID Pri Speed/Duplex Type Trunk
--------- -------------- -------- ---- --- ------------- ------------ -----
Eth 1/ 1 Up 1 0 Auto-1000full 1000BASE-T None
Eth 1/ 2 Down 1 0 Auto 1000BASE-T None
Eth 1/ 3 Down 1 0 Auto 1000BASE-T None
Eth 1/ 4 Down 1 0 Auto 1000BASE-T None
Eth 1/ 5 Down 1 0 Auto 1000BASE-T None
Eth 1/ 6 Down 1 0 Auto 1000BASE-T None
Eth 1/ 7 Down 1 0 Auto 1000BASE-T None
.
.
.
Console#
Automatic Installation of Operation Code and Configuration Settings
Downloading
Operation Code
from a File Server
Automatic Operation Code Upgrade can automatically download an operation
code file when a file newer than the currently installed one is discovered on the file
server. After the file is transferred from the server and successfully written to the file
system, it is automatically set as the startup file, and the switch is rebooted.
Usage Guidelines
◆ If this feature is enabled, the switch searches the defined URL once during the
bootup sequence.
◆ FTP (port 21) and TFTP (port 69) are both supported. Note that the TCP/UDP
port bindings cannot be modified to support servers listening on non-standard
ports.